Dana ID

DANA 30 10 COVER BOLTS-------9in C TO C
DANA 35 10 COVER BOLTS ------9 1/4in C TO C
DANA 44 10 COVER BOLTS ------8 5/8in C TO C
DANA 50 10 COVER BOLTS ------10 1/4in C TO C
DANA 60 10 COVER BOLTS ------10 1/4in C TO C
DANA 61 10 COVER BOLTS ------10 1/4in C TO C
DANA 70 10 COVER BOLTS ------10 1/4in C TO C
DANA 80 10 COVER BOLTS ------10 1/4in C TO C
DANA 28 IFS NO COVER BOLTS REMOVABLE CARRIER
DANA 35 IFS NO COVER BOLTS REMOVABLE CARRIER
DANA 35 ICA NO COVER BOLTS REMOVABLE CARRIER
DANA 44 IFS NO COVER BOLTS REMOVABLE CARRIER
DANA 50 IFS NO COVER BOLTS REMOVABLE CARRIER

MANY DANA UNITS CAN ONLY BE PROPERLY IDENTIFIED BY THE DANA BILL OF MATERIAL NUMBER. THIS SET OF NUMBERS IS THE BIRTH CERTIFICATE OF ANY DANA BUILT FRONT OR REAR DIFFERENTIAL. EXAMPLE: NOTICE THAT DANA 60 AND 70 ARE IDENTICAL IN THE CENTER TO CENTER MEASUREMENT OF COVER BOLT HOLES. THEREFORE A POSITIVE IDENTIFICATION MUST BE MADE BY THE “ BILL OF MATERIAL” NUMBER THAT IS STAMPED INTO THE HOUSING ITSELF. THIS NUMBER IS FOUND ON REAR DIFFERENTIALS STAMPED INTO THE PASSENGER SIDE REAR AXLE TUBE APPROXIMATELY 6” TO 16” FROM THE EDGE OF THE COVER.!!! PLEASE NOTE !!!THESE NUMBERS ARE VERY IMPORTANT, HOWEVER, THEY CAN BE REAL DIFFICULT TO LOCATE AS THEY ARE ONLY 1/8” IN TOTAL HEIGHT !! ON FRONT DIFFEREN-TIALS THEY ARE FOUND IN A NUMBER OF LOCATIONS AND IT IS BEST TO CALL K&L UNLIMITED, NC. TO ASK FOR THE EXACT LOCATION OF THE NUMBERS ON YOUR VEHICLE